DKG114 | DKG-114 MANUAL AND REMOTE START UNIT
5,390 EGP9,800 EGP (-45%)
The DKG-114 is a low cost, microprocessor controlled generator control unit designed to start and stop the genset both manually and remotely.
The manual control is made using the pushbuttons on the front panel. The remote control is made via the remote start input signal.
In the STOP position, the DC supply is removed from the module, thus zero power consumption is achieved.
Both manual and remote controlled engine starting and stopping,
Automatic shutdown on fault condition,
Optional cooldown cycle on remote start operation,
Optional energize to stop or preheat output,
Survives cranking dropouts,
High current relay outputs,
Selectable engine running signal (from genset voltage or charge alternator),
Delayed overspeed and underspeed alarm,
Sealed front panel, IP65 protection.
Plug-in connection system for easy replacement,
Small dimensions,
Standard panel dimensions, (72x72mm)
DKG114 | DKG-114 MANUAL AND REMOTE START UNIT
- Optional Cooldown Cycle: Provides an optional cooldown cycle for remote start operations.
- Optional Energize to Stop or Preheat Output: Provides optional energize to stop or preheat output.
- Survives Cranking Dropouts: Can withstand cranking dropouts without affecting its operation.
- High Current Relay Outputs: Delivers high current relay outputs for controlling the engine starter.
Technical Specifications:
- Power Supply: 12V or 24V DC
- Current Consumption: 80 mA (typical), 120 mA (max.)
- Operating Temperature: -10°C to 60°C
- Storage Temperature: -20°C to 70°C
- Dimensions: 72x72mm
- Weight: 150g
Reviews
There are no reviews yet.